In a scenario where things are so bad that the US has halted all financial electronic transactions than your electronic dollars don’t mean anything no matter where you are, amd your paper dollars mean almost nothing either.

This is honestly the biggest takeaway. If the US actually stops cooperating with foreign banks, the dollar will instantly become worthless; The dollar only holds international worth because other countries want to have and hold dollars. If those other countries are unable to do so, there is no incentive for them to accept dollars as valid currency.

I think it’s a joke about physicists not understanding tolerances.

I remember hearing an old story about a company buying signs from a contractor. The contractor produced all kinds of things, so it was fairly straightforward to send them the CAD file and stop worrying about it. One manager did an audit, and realized they were paying hundreds of dollars each for these basic signs. They weren’t fancy or anything, and were just signs throughout the facility that got updated regularly. So why the hell were they paying so much for what should have been a simple print job?

After some investigating, the manager discovered it was because the company didn’t want to hire an artist to design the signs; They just had one of their engineers do it. And the engineer who did the design forgot to change their default tolerances from 3/1000 of an inch. So to comply with the order as written, the contractor was busting out calipers and meticulously measuring the spacing and sizing on each letter before it shipped out the door.

And yet you know damned well what they meant, otherwise you wouldn’t have responded with the “well akshually” type of comment.

This is the worst way to go about doing it, because you should never assume a drawing is made to scale unless it is specifically marked as such. A protractor would be useless if the drawing isn’t to scale. Generally speaking, if a problem isn’t drawn to scale, it’s because all of the info you need to solve it is already present in the drawing. You don’t need to bust out the protractor to measure angles, because the angles can either be calculated from the available info, or aren’t needed in the first place.

This is the answer. It’s freely accessible, and duplicated across servers all over the world so it’s difficult for copyright claims to take down.

I personally prefer tools that exist in the fourth dimension. It really makes blind-hole taps a thing of the past.